53 lines
1.7 KiB
C
53 lines
1.7 KiB
C
// clang-format off
|
|
// upload_speed 921600
|
|
// board heltec_wifi_lora_32_V2
|
|
|
|
#ifndef _HELTECV2_H
|
|
#define _HELTECV2_H
|
|
|
|
#include <stdint.h>
|
|
|
|
// Hardware related definitions for Heltec V2 LoRa-32 Board
|
|
|
|
//#define HAS_BME 1 // Enable BME sensors in general
|
|
//#define HAS_BME680 GPIO_NUM_4, GPIO_NUM_15 // SDA, SCL
|
|
//#define BME680_ADDR BME680_I2C_ADDR_PRIMARY // connect SDIO of BME680 to GND
|
|
//#define HAS_BMP180
|
|
//#define BMP180_ADDR 0x77
|
|
|
|
#define HAS_LORA 1 // comment out if device shall not send data via LoRa
|
|
#define CFG_sx1276_radio 1
|
|
|
|
#define HAS_DISPLAY 1 // OLED-Display on board
|
|
#define HAS_LED LED_BUILTIN // white LED on board
|
|
#define HAS_BUTTON KEY_BUILTIN // button "PROG" on board
|
|
|
|
// caveat: activating ADC2 conflicts with Wifi in current arduino-esp32
|
|
// see https://github.com/espressif/arduino-esp32/issues/3222
|
|
// thus we must waiver of battery monitoring
|
|
//#define BAT_MEASURE_ADC ADC2_GPIO13_CHANNEL // battery probe GPIO pin
|
|
//#define BAT_MEASURE_ADC_UNIT 2 // ADC 2
|
|
//#define BAT_VOLTAGE_DIVIDER 2 // voltage divider 220k/100k on board
|
|
|
|
#define EXT_POWER_SW Vext // switches battery power, Vext control 0 = on / 1 = off
|
|
#define EXT_POWER_ON 0
|
|
//#define EXT_POWER_OFF 1
|
|
|
|
// Pins for I2C interface of OLED Display
|
|
#define MY_DISPLAY_SDA SDA_OLED
|
|
#define MY_DISPLAY_SCL SCL_OLED
|
|
#define MY_DISPLAY_RST RST_OLED
|
|
|
|
// Pins for LORA chip SPI interface come from board file, we need some
|
|
// additional definitions for LMIC
|
|
#define LORA_IRQ DIO0
|
|
#define LORA_IO1 DIO1
|
|
#define LORA_IO2 DIO2
|
|
#define LORA_SCK GPIO_NUM_5
|
|
#define LORA_MISO MISO
|
|
#define LORA_MOSI MOSI
|
|
#define LORA_RST RST_LoRa
|
|
#define LORA_CS SS
|
|
|
|
#endif
|