50 lines
1.9 KiB
C
50 lines
1.9 KiB
C
// clang-format off
|
|
// upload_speed 921600
|
|
// board featheresp32
|
|
|
|
#ifndef _OCTOPUS_H
|
|
#define _OCTOPUS_H
|
|
#include <stdint.h>
|
|
|
|
// Hardware related definitions for #IoT Octopus32 with the Adafruit LoRaWAN Wing
|
|
// You can use this configuration also with the Adafruit ESP32 Feather + the LoRaWAN Wing
|
|
// In this config we use the Adafruit OLED Wing which is only 128x32 pixel, need to find a smaller font
|
|
// NOTE: if LORA_IRQ and LORA_IO1 are tied to the same GPIO using diodes on the board,
|
|
// you must disable LMIC_USE_INTERRUPTS in lmic_config.h
|
|
|
|
// disable brownout detection (avoid unexpected reset on some boards)
|
|
#define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature
|
|
|
|
// Octopus32 has a pre-populated BME680 on i2c addr 0x76
|
|
#define HAS_BME 1 // Enable BME sensors in general
|
|
#define HAS_BME680 GPIO_NUM_23, GPIO_NUM_22 // SDA, SCL
|
|
#define BME680_ADDR BME680_I2C_ADDR_PRIMARY // connect SDIO of BME680 to GND
|
|
|
|
#define HAS_LED 13 // ESP32 GPIO12 (pin22) On Board LED
|
|
//#define LED_ACTIVE_LOW 1 // Onboard LED is active when pin is LOW
|
|
//#define HAS_RGB_LED SmartLed rgb_led(LED_WS2812, 1, GPIO_NUM_13) // ESP32 GPIO13 (pin13) On Board Shield WS2812B RGB LED
|
|
//#define HAS_BUTTON 15 // ESP32 GPIO15 (pin15) Button is on the LoraNode32 shield
|
|
//#define BUTTON_PULLUP 1 // Button need pullup instead of default pulldown
|
|
|
|
#define HAS_LORA 1 // comment out if device shall not send data via LoRa
|
|
#define CFG_sx1276_radio 1 // RFM95 module
|
|
|
|
// Pins for LORA chip SPI interface, reset line and interrupt lines
|
|
#define LORA_SCK (5)
|
|
#define LORA_CS (14)
|
|
#define LORA_MISO (19)
|
|
#define LORA_MOSI (18)
|
|
#define LORA_RST LMIC_UNUSED_PIN
|
|
#define LORA_IRQ (33)
|
|
#define LORA_IO1 (33)
|
|
#define LORA_IO2 LMIC_UNUSED_PIN
|
|
|
|
// Pins for I2C interface of OLED Display
|
|
#define HAS_DISPLAY 1
|
|
//#define MY_DISPLAY_FLIP 1 // uncomment this for rotated display
|
|
#define MY_DISPLAY_SDA (23)
|
|
#define MY_DISPLAY_SCL (22)
|
|
#define MY_DISPLAY_RST NOT_A_PIN
|
|
|
|
#endif
|