// Hardware related definitions for TTGO T-Beam board

#define HAS_LORA  1       // comment out if device shall not send data via LoRa
#define HAS_SPI   1       // comment out if device shall not send data via SPI
#define CFG_sx1276_radio 1 // HPD13A LoRa SoC

#define BOARD_HAS_PSRAM // use extra 4MB extern RAM
#define HAS_LED GPIO_NUM_21 // on board green LED

#define HAS_BUTTON GPIO_NUM_39 // on board button "BOOT" (next to reset button)

#define HAS_BATTERY_PROBE ADC1_GPIO35_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7
#define BATT_FACTOR 2 // voltage divider 100k/100k on board
#define HAS_GPS 1 // use on board GPS
#define GPS_SERIAL 9600, SERIAL_8N1, GPIO_NUM_12, GPIO_NUM_15 // UBlox NEO 6M or 7M with default configuration

// re-define pin definitions of pins_arduino.h
#define PIN_SPI_SS    GPIO_NUM_18 // ESP32 GPIO18 (Pin18) -- HPD13A NSS/SEL (Pin4) SPI Chip Select Input
#define PIN_SPI_MOSI  GPIO_NUM_27 // ESP32 GPIO27 (Pin27) -- HPD13A MOSI/DSI (Pin6) SPI Data Input
#define PIN_SPI_MISO  GPIO_NUM_19 // ESP32 GPIO19 (Pin19) -- HPD13A MISO/DSO (Pin7) SPI Data Output
#define PIN_SPI_SCK   GPIO_NUM_5  // ESP32 GPIO5 (Pin5)   -- HPD13A SCK (Pin5) SPI Clock Input

// non arduino pin definitions
#define RST LMIC_UNUSED_PIN // connected to ESP32 RST/EN
#define DIO0 GPIO_NUM_26    // ESP32 GPIO26 <-> HPD13A IO0
#define DIO1 GPIO_NUM_32 // Lora1 <-> HPD13A IO1 // !! NEEDS EXTERNAL WIRING !!
//#define DIO1 GPIO_NUM_33 // Lora1 <-> HPD13A IO1 // for T-Beam T22_V05 only
#define DIO2 LMIC_UNUSED_PIN // Lora2 <-> HPD13A IO2 // not needed for LoRa