// clang-format off

#ifndef _TTGOBEAM_H
#define _TTGOBEAM_H

#include <stdint.h>

// Hardware related definitions for TTGO T-Beam board

// enable only if device has these sensors, otherwise comment these lines
// BME680 sensor on I2C bus
// attention: Pin21 is also LED! set HAS_LED to NOT_A_PIN if using BME280
// don't forget to connect SDIO of BME680 to GND for selecting i2c addr 0x76
#define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL
#define HAS_LED NOT_A_PIN // on board green LED

// user defined sensors
//#define HAS_SENSORS 1 // comment out if device has user defined sensors

#define HAS_LORA 1       // comment out if device shall not send data via LoRa
#define CFG_sx1276_radio 1 // HPD13A LoRa SoC

#define BOARD_HAS_PSRAM // use extra 4MB external RAM
//#define HAS_LED GPIO_NUM_21 // on board green LED

#define HAS_BUTTON GPIO_NUM_39 // on board button "BOOT" (next to reset button)

#define HAS_BATTERY_PROBE ADC1_GPIO35_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7
#define BATT_FACTOR 2 // voltage divider 100k/100k on board
#define HAS_GPS 1 // use on board GPS
#define GPS_SERIAL 9600, SERIAL_8N1, GPIO_NUM_12, GPIO_NUM_15 // UBlox NEO 6M or 7M with default configuration

// Pins for LORA chip SPI interface, reset line and interrupt lines
#define LORA_SCK  (5) 
#define LORA_CS   (18)
#define LORA_MISO (19)
#define LORA_MOSI (27)
#define LORA_RST   LMIC_UNUSED_PIN
#define LORA_IRQ  (26)
#define LORA_IO1  (32) // !! NEEDS EXTERNAL WIRING !!
//#define LORA_IO1  (33)  // for T-Beam T22_V05 and T22_V07, other versions may need external wiring
#define LORA_IO2  LMIC_UNUSED_PIN

#endif