diff --git a/src/hal/ttgobeam10.h b/src/hal/ttgobeam10.h
index 95820098..4d00034d 100644
--- a/src/hal/ttgobeam10.h
+++ b/src/hal/ttgobeam10.h
@@ -14,15 +14,16 @@
 #define HAS_LORA 1       // comment out if device shall not send data via LoRa
 #define CFG_sx1276_radio 1 // HPD13A LoRa SoC
 #define BOARD_HAS_PSRAM // use extra 4MB external RAM
-#define HAS_BUTTON GPIO_NUM_36 // on board button (next to reset)
+#define HAS_BUTTON GPIO_NUM_38 // middle on board button
 #define HAS_PMU 1 // AXP192 power management chip
-#define PMU_INT GPIO_NUM_36 // AXP192 interrupt
+#define PMU_INT GPIO_NUM_35 // AXP192 interrupt
 
 #define HAS_LED NOT_A_PIN
 
 // GPS settings
 #define HAS_GPS 1 // use on board GPS
 #define GPS_SERIAL 9600, SERIAL_8N1, GPIO_NUM_34, GPIO_NUM_12 // UBlox NEO 6M
+#define GPS_INT GPIO_NUM_37 // 30ns accurary timepulse generated by NEO 6M Pin #3
 
 // enable only if device has these sensors, otherwise comment these lines
 // BME680 sensor on I2C bus
@@ -31,10 +32,10 @@
 //#define BME680_ADDR BME680_I2C_ADDR_PRIMARY // !! connect SDIO of BME680 to GND !!
 
 // display (if connected)
-#define HAS_DISPLAY U8X8_SSD1306_128X64_NONAME_HW_I2C
-#define MY_OLED_SDA SDA
-#define MY_OLED_SCL SCL
-#define MY_OLED_RST U8X8_PIN_NONE
+//#define HAS_DISPLAY U8X8_SSD1306_128X64_NONAME_HW_I2C
+//#define MY_OLED_SDA SDA
+//#define MY_OLED_SCL SCL
+//#define MY_OLED_RST U8X8_PIN_NONE
 //#define DISPLAY_FLIP  1 // use if display is rotated
 
 // user defined sensors (if connected)