diff --git a/src/hal/ttgobeam10.h b/src/hal/ttgobeam10.h
new file mode 100644
index 00000000..95820098
--- /dev/null
+++ b/src/hal/ttgobeam10.h
@@ -0,0 +1,45 @@
+// clang-format off
+// upload_speed 921600
+// board ttgo-t-beam
+
+#ifndef _TTGOBEAM_H
+#define _TTGOBEAM_H
+
+#include <stdint.h>
+
+// Hardware related definitions for TTGO T-Beam board
+// (only) for newer T-Beam version T22_V10
+// pinouts taken from https://github.com/lewisxhe/TTGO-T-Beam
+
+#define HAS_LORA 1       // comment out if device shall not send data via LoRa
+#define CFG_sx1276_radio 1 // HPD13A LoRa SoC
+#define BOARD_HAS_PSRAM // use extra 4MB external RAM
+#define HAS_BUTTON GPIO_NUM_36 // on board button (next to reset)
+#define HAS_PMU 1 // AXP192 power management chip
+#define PMU_INT GPIO_NUM_36 // AXP192 interrupt
+
+#define HAS_LED NOT_A_PIN
+
+// GPS settings
+#define HAS_GPS 1 // use on board GPS
+#define GPS_SERIAL 9600, SERIAL_8N1, GPIO_NUM_34, GPIO_NUM_12 // UBlox NEO 6M
+
+// enable only if device has these sensors, otherwise comment these lines
+// BME680 sensor on I2C bus
+//#define HAS_BME 1 // Enable BME sensors in general
+//#define HAS_BME680 SDA, SCL
+//#define BME680_ADDR BME680_I2C_ADDR_PRIMARY // !! connect SDIO of BME680 to GND !!
+
+// display (if connected)
+#define HAS_DISPLAY U8X8_SSD1306_128X64_NONAME_HW_I2C
+#define MY_OLED_SDA SDA
+#define MY_OLED_SCL SCL
+#define MY_OLED_RST U8X8_PIN_NONE
+//#define DISPLAY_FLIP  1 // use if display is rotated
+
+// user defined sensors (if connected)
+//#define HAS_SENSORS 1 // comment out if device has user defined sensors
+
+//#define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature
+
+#endif