Bosch BSEC integration completed

src/hal/generic.h

@@ -13,16 +13,12 @@
 #define SPI_SCLK GPIO_NUM_18
 #define SPI_CS   GPIO_NUM_5
 
-////////////// test //////////
 // enable only if device has these sensors, otherwise comment these lines
 // BME680 sensor on I2C bus
 #define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL
-// #define BME_ADDR BME680_I2C_ADDR_PRIMARY // i2c addr 0x76
-#define BME_ADDR BME680_I2C_ADDR_SECONDARY // i2c addr 0x77
-//
+
 // user defined sensors
 //#define HAS_SENSORS 1 // comment out if device has user defined sensors
-////////////// test //////////
 
 #define CFG_sx1276_radio 1 // select LoRa chip
 //#define CFG_sx1272_radio 1 // select LoRa chip

src/hal/octopus32.h

@@ -10,7 +10,12 @@
 // disable brownout detection (avoid unexpected reset on some boards)
 #define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature
 
-#define HAS_BME 0x76  // BME680 sensor on I2C bus; comment out if not present
+// enable only if device has these sensors, otherwise comment these lines
+// BME680 sensor on I2C bus
+#define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL
+
+// user defined sensors
+//#define HAS_SENSORS 1 // comment out if device has user defined sensors
 
 #define HAS_LED        13  // ESP32 GPIO12 (pin22) On Board LED
 #define LED_ACTIVE_LOW 1  // Onboard LED is active when pin is LOW

src/hal/ttgobeam.h

@@ -5,16 +5,12 @@
 
 // Hardware related definitions for TTGO T-Beam board
 
-////////////// test //////////
 // enable only if device has these sensors, otherwise comment these lines
 // BME680 sensor on I2C bus
 #define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL
-// #define BME_ADDR BME680_I2C_ADDR_PRIMARY // i2c addr 0x76
-#define BME_ADDR BME680_I2C_ADDR_SECONDARY // i2c addr 0x77
-//
+
 // user defined sensors
 //#define HAS_SENSORS 1 // comment out if device has user defined sensors
-////////////// test //////////
 
 #define HAS_LORA 1       // comment out if device shall not send data via LoRa
 #define CFG_sx1276_radio 1 // HPD13A LoRa SoC

src/hal/ttgov21new.h

@@ -8,8 +8,6 @@
 // This settings are for boards labeled v1.6 on pcb, NOT for v1.5 or older
 */
 
-#define HAS_BME 0x77  // BME680 sensor on I2C bus (SDI=21/SCL=22); comment out if not present
-
 #define HAS_LORA 1       // comment out if device shall not send data via LoRa
 #define CFG_sx1276_radio 1 // HPD13A LoRa SoC