delete ttgobeam_old.h

This commit is contained in:
Klaus K Wilting 2019-01-11 18:50:41 +01:00
parent e4320e97f8
commit ac9895e55a

View File

@ -1,50 +0,0 @@
// clang-format off
#ifndef _TTGOBEAM_H
#define _TTGOBEAM_H
#include <stdint.h>
// Hardware related definitions for TTGO T-Beam board
// enable only if device has these sensors, otherwise comment these lines
// BME680 sensor on I2C bus
#define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL
#define BME_ADDR BME680_I2C_ADDR_PRIMARY // connect SDIO of BME680 to GND
#define HAS_LED NOT_A_PIN // on board green LED uses same GPIO as SDA!
// #define HAS_LED GPIO_NUM_21 // on board green LED
// user defined sensors
//#define HAS_SENSORS 1 // comment out if device has user defined sensors
//#define HAS_DISPLAY U8X8_SSD1306_128X64_NONAME_HW_I2C
//#define MY_OLED_SDA (21)
//#define MY_OLED_SCL (22)
//#define MY_OLED_RST U8X8_PIN_NONE
//#define DISPLAY_FLIP 1 // use if display is rotated
#define HAS_LORA 1 // comment out if device shall not send data via LoRa
#define CFG_sx1276_radio 1 // HPD13A LoRa SoC
#define BOARD_HAS_PSRAM // use extra 4MB external RAM
//#define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature
#define HAS_BUTTON GPIO_NUM_39 // on board button "BOOT" (next to reset button)
#define HAS_BATTERY_PROBE ADC1_GPIO35_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7
#define BATT_FACTOR 2 // voltage divider 100k/100k on board
#define HAS_GPS 1 // use on board GPS
#define GPS_SERIAL 9600, SERIAL_8N1, GPIO_NUM_12, GPIO_NUM_15 // UBlox NEO 6M or 7M with default configuration
// Pins for LORA chip SPI interface, reset line and interrupt lines
#define LORA_SCK (5)
#define LORA_CS (18)
#define LORA_MISO (19)
#define LORA_MOSI (27)
#define LORA_RST LMIC_UNUSED_PIN
#define LORA_IRQ (26)
#define LORA_IO1 (32) // !! NEEDS EXTERNAL WIRING !!
#define LORA_IO2 LMIC_UNUSED_PIN
#endif