diff --git a/README.md b/README.md
index 9d4fe759..4cdf2f2d 100644
--- a/README.md
+++ b/README.md
@@ -202,7 +202,7 @@ Output of sensor and peripheral data is internally switched by a bitmask registe
 
 # Power saving mode
 
-Paxcounter supports a battery friendly power saving mode. In this mode the device enters deep sleep, after all data is polled from all sensors and the dataset is completeley sent through all user configured channels (LORAWAN / SPI / MQTT). Set *#define SLEEPCYCLE* in paxcounter.conf to enable power saving mode and to specify the duration of a sleep cycle. Power consumption in deep sleep mode depends on your hardware, i.e. if on board peripherals can be switched off or set to a chip specific sleep mode either by  MCU or by power management unit (PMU) as found on TTGO T-BEAM v1.0/V1.1. See *power.cpp* for power management, and *reset.cpp* for sleep and wakeup logic.
+Paxcounter supports a battery friendly power saving mode. In this mode the device enters deep sleep, after all data is polled from all sensors and the dataset is completeley sent through all user configured channels (LORAWAN / SPI / MQTT / SD-Card). Set *#define SLEEPCYCLE* in paxcounter.conf to enable power saving mode and to specify the duration of a sleep cycle. Power consumption in deep sleep mode depends on your hardware, i.e. if on board peripherals can be switched off or set to a chip specific sleep mode either by MCU or by power management unit (PMU) as found on TTGO T-BEAM v1.0/V1.1. See *power.cpp* for power management, and *reset.cpp* for sleep and wakeup logic.
 
 # Time sync