switched to staging arduino-espressif32 core

src/hal/lopy4.h

@@ -28,10 +28,10 @@
 //#define BUTTON_PULLUP 1  // Button need pullup instead of default pulldown
 
 // uncomment this only if your LoPy runs on a expansion board 3.0
-//#define HAS_BATTERY_PROBE ADC1_GPIO39_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7
-//#define BATT_FACTOR 2 // voltage divider 1MOhm/1MOhm on board
-//#define HAS_BUTTON GPIO_NUM_37 // (P14)
-//#define BUTTON_PULLUP 1  // Button need pullup instead of default pulldown
+#define HAS_BATTERY_PROBE ADC1_GPIO39_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7
+#define BATT_FACTOR 2 // voltage divider 1MOhm/1MOhm on board
+#define HAS_BUTTON GPIO_NUM_37 // (P14)
+#define BUTTON_PULLUP 1  // Button need pullup instead of default pulldown
 
 // uncomment this only if your LoPy runs on a expansion board 2.0
 //#define HAS_BATTERY_PROBE ADC1_GPIO39_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7

src/paxcounter.conf

@@ -36,7 +36,7 @@
 #define	WIFI_CHANNEL_SWITCH_INTERVAL    50      // [seconds/100] -> 0,5 sec.
 
 // LoRa payload parameters
-#define PAYLOAD_ENCODER                 1       // select payload encoder: 1=Plain [default], 2=Packed, 3=CayenneLPP
+#define PAYLOAD_ENCODER                 2       // select payload encoder: 1=Plain [default], 2=Packed, 3=CayenneLPP
 #define SEND_SECS                       120     // payload send cycle [seconds/2] -> 240 sec.
 #define MEM_LOW                         2048    // [Bytes] low memory threshold triggering a send cycle
 #define RETRANSMIT_RCMD                 5       // [seconds] wait time before retransmitting rcommand results