From 82c831e4e4a7d2410e25f1318efbeb51e636307b Mon Sep 17 00:00:00 2001 From: Klaus K Wilting Date: Mon, 17 Dec 2018 10:42:34 +0100 Subject: [PATCH] update ttgobeam_new.h --- src/hal/ttgobeam_new.h | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-) diff --git a/src/hal/ttgobeam_new.h b/src/hal/ttgobeam_new.h index 5bbdd620..93f729a3 100644 --- a/src/hal/ttgobeam_new.h +++ b/src/hal/ttgobeam_new.h @@ -6,13 +6,14 @@ #include // Hardware related definitions for TTGO T-Beam board - +// +// pinouts taken from http://tinymicros.com/wiki/TTGO_T-Beam +// // enable only if device has these sensors, otherwise comment these lines // BME680 sensor on I2C bus -// attention: Pin21 is also LED! set HAS_LED to NOT_A_PIN if using BME280 // don't forget to connect SDIO of BME680 to GND for selecting i2c addr 0x76 +// //#define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL -//#define HAS_LED NOT_A_PIN // on board green LED #define HAS_LED GPIO_NUM_14 // on board green LED @@ -25,7 +26,7 @@ //#define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature -#define HAS_BUTTON GPIO_NUM_39 // on board button "BOOT" (next to reset button) +#define HAS_BUTTON GPIO_NUM_39 // on board button "SW5" #define HAS_BATTERY_PROBE ADC1_GPIO35_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7 #define BATT_FACTOR 2 // voltage divider 100k/100k on board @@ -37,7 +38,7 @@ #define LORA_CS (18) #define LORA_MISO (19) #define LORA_MOSI (27) -#define LORA_RST LMIC_UNUSED_PIN +#define LORA_RST (23) #define LORA_IRQ (26) #define LORA_IO1 (33) // for T-Beam T22_V05 and T22_V07, for other versions use ttgobeam_old.h #define LORA_IO2 (32)