From 334255849e064a81730a4f29c78ff92cac66a6d5 Mon Sep 17 00:00:00 2001 From: Klaus K Wilting Date: Sun, 9 Dec 2018 19:36:22 +0100 Subject: [PATCH] ttgobeam.h: BME680 disabled by default --- src/hal/ttgobeam.h | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/src/hal/ttgobeam.h b/src/hal/ttgobeam.h index 30dcb626..c2166b5a 100644 --- a/src/hal/ttgobeam.h +++ b/src/hal/ttgobeam.h @@ -11,20 +11,20 @@ // BME680 sensor on I2C bus // attention: Pin21 is also LED! set HAS_LED to NOT_A_PIN if using BME280 // don't forget to connect SDIO of BME680 to GND for selecting i2c addr 0x76 -#define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL -#define HAS_LED NOT_A_PIN // on board green LED +//#define HAS_BME GPIO_NUM_21, GPIO_NUM_22 // SDA, SCL +//#define HAS_LED NOT_A_PIN // on board green LED + +#define HAS_LED GPIO_NUM_21 // on board green LED // user defined sensors //#define HAS_SENSORS 1 // comment out if device has user defined sensors #define HAS_LORA 1 // comment out if device shall not send data via LoRa #define CFG_sx1276_radio 1 // HPD13A LoRa SoC +#define BOARD_HAS_PSRAM // use extra 4MB external RAM //#define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature -#define BOARD_HAS_PSRAM // use extra 4MB external RAM -//#define HAS_LED GPIO_NUM_21 // on board green LED - #define HAS_BUTTON GPIO_NUM_39 // on board button "BOOT" (next to reset button) #define HAS_BATTERY_PROBE ADC1_GPIO35_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7