rcommand 0x13 user sensor on/off

src/hal/generic.h

@@ -13,8 +13,8 @@
 #define SPI_SCLK GPIO_NUM_18
 #define SPI_CS   GPIO_NUM_5
 
-#define HAS_BME 0x77  // BME680 sensor on I2C bus (SDA=4/SCL=15); comment out if not present
-
+// enable only if device has these sensors, otherwise comment these lines
+#define HAS_BME 0x77  // BME680 sensor on I2C bus (default SDA=4/SCL=15); comment out if not present
 #define HAS_SENSORS 1 // comment out if device has user defined sensors
 
 #define CFG_sx1276_radio 1 // select LoRa chip

src/hal/heltecv2.h

@@ -5,6 +5,9 @@
 
 // Hardware related definitions for Heltec V2 LoRa-32 Board
 
+//#define HAS_BME 0x77  // BME680 sensor on I2C bus (SDI=21/SCL=22); comment out
+//if not present
+
 #define HAS_LORA 1       // comment out if device shall not send data via LoRa
 #define CFG_sx1276_radio 1
 

src/hal/ttgobeam.h

@@ -5,6 +5,8 @@
 
 // Hardware related definitions for TTGO T-Beam board
 
+#define HAS_SENSORS 1 // test
+
 #define HAS_LORA 1       // comment out if device shall not send data via LoRa
 #define CFG_sx1276_radio 1 // HPD13A LoRa SoC