From 18ca823d927c0f567e336bf46e57876354ffe653 Mon Sep 17 00:00:00 2001 From: Verkehrsrot Date: Sat, 23 Mar 2019 11:03:04 +0100 Subject: [PATCH] new board file ecopower.h --- src/hal/ecopower.h | 55 ++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 55 insertions(+) create mode 100644 src/hal/ecopower.h diff --git a/src/hal/ecopower.h b/src/hal/ecopower.h new file mode 100644 index 00000000..479d33e4 --- /dev/null +++ b/src/hal/ecopower.h @@ -0,0 +1,55 @@ +// clang-format off + +#ifndef _GENERIC_H +#define _GENERIC_H + +#include + +#define HAS_LORA 1 // comment out if device shall not send data via LoRa or has no LoRa + +#define CFG_sx1276_radio 1 // select LoRa chip + +//#define BOARD_HAS_PSRAM // use if board has external PSRAM +//#define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature + +#define HAS_DISPLAY U8X8_SSD1306_128X64_NONAME_HW_I2C +//#define DISPLAY_FLIP 1 // use if display is rotated +#define BAT_MEASURE_ADC ADC1_GPIO35_CHANNEL // battery probe GPIO pin -> ADC1_CHANNEL_7 +#define BAT_VOLTAGE_DIVIDER ((82.0+220.0)/82.0) // 82k + 220k 1% +#define BAT_MEASURE_EN EXT_POWER_SW // Turn power on for messurement + +#define EXT_POWER_SW 15 // Switch VDD on pin JP10 +#define EXT_POWER_ON 0 +#define EXT_POWER_OFF 1 + +#define HAS_LED (12) // on board LED +//#define HAS_BUTTON (0) // on board button + +// Pins for I2C interface of OLED Display +#define MY_OLED_SDA (21) +#define MY_OLED_SCL (22) +#define MY_OLED_RST U8X8_PIN_NONE + +// Settings for on board DS3231 RTC chip +// note: to use RTC_INT, ext_power_on is needed! +#define HAS_RTC MY_OLED_SDA, MY_OLED_SCL // SDA, SCL +#define RTC_INT GPIO_NUM_0 + +// Settings for IF482 interface +#define HAS_IF482 9600, SERIAL_7E1, GPIO_NUM_27, GPIO_NUM_14 // JP8 #12/#13 + +// Settings for DCF77 interface +//#define HAS_DCF77 GPIO_NUM_14 // JP8 #13 +//#define DCF77_ACTIVE_LOW 1 + +// Pins for LORA chip SPI interface, reset line and interrupt lines +#define LORA_SCK (18) +#define LORA_CS (5) +#define LORA_MISO (19) +#define LORA_MOSI (23) +#define LORA_RST (17) +#define LORA_IRQ (16) +#define LORA_IO1 (4) // JP9 #8 to be external wired +#define LORA_IO2 LMIC_UNUSED_PIN + +#endif \ No newline at end of file