ttgobeam10.h: LED active low correction
This commit is contained in:
parent
b47c77ee99
commit
016d69b5bb
@ -20,7 +20,7 @@ User, long press -> send LORA message
|
||||
Reset -> reset device
|
||||
*/
|
||||
|
||||
//#define HAS_DISPLAY 1
|
||||
#define HAS_DISPLAY 1
|
||||
#define MY_DISPLAY_SDA SDA
|
||||
#define MY_DISPLAY_SCL SCL
|
||||
#define MY_DISPLAY_RST NOT_A_PIN
|
||||
@ -30,6 +30,7 @@ Reset -> reset device
|
||||
#define CFG_sx1276_radio 1 // HPD13A LoRa SoC
|
||||
#define HAS_BUTTON GPIO_NUM_38 // middle on board button
|
||||
#define HAS_LED GPIO_NUM_4 // not present on all T-Beam 1.0 boards
|
||||
#define LED_ACTIVE_LOW 1
|
||||
|
||||
// power management settings
|
||||
#define HAS_PMU 1 // has AXP192 chip
|
||||
@ -48,9 +49,9 @@ Reset -> reset device
|
||||
|
||||
// enable only if device has these sensors, otherwise comment these lines
|
||||
// BME680 sensor on I2C bus
|
||||
//#define HAS_BME 1 // Enable BME sensors in general
|
||||
//#define HAS_BME680 SDA, SCL
|
||||
//#define BME680_ADDR BME680_I2C_ADDR_PRIMARY // !! connect SDIO of BME680 to GND !!
|
||||
#define HAS_BME 1 // Enable BME sensors in general
|
||||
#define HAS_BME680 SDA, SCL
|
||||
#define BME680_ADDR BME680_I2C_ADDR_PRIMARY // !! connect SDIO of BME680 to GND !!
|
||||
|
||||
//#define DISABLE_BROWNOUT 1 // comment out if you want to keep brownout feature
|
||||
|
||||
|
Loading…
Reference in New Issue
Block a user